DEN-ON™ Hand Tools & Accessories
PCB Rework and Repair

The PH-3100A pre-heater uses (2) two 200W IR heaters and closed - loop control to provide fast safety manual soldering. The PH-3100A is designed for multilayered PCBs, Lead-free solder and devices with large heat sinks.

Features:

• 400W of IR pre-heating ensures heat is distributed evenly throughout multilayered PCBs allowing fast manual soldering/desoldering
• PCB holders and bottom-side supports (included) are used for fast stable load and unload
• Wide Area heating design prevents board warping due to uneven heating

Direct connection between the diaphragm pump and tip provides high vacuum efficiency accommodating 8-12 layered PCB. A 100W ceramic heater with sensor feedback temperature control circuit and high vacuum capacity provides excellent work efficiency with no failure. Capable of removing SMD components using a hot blow nozzle.

Features:

• ESD safe
• Compact and light-weight
• Low-noise and low-vibration

Over 10,000 sold worldwide

The SC-200 employs hot air heating which is used to preheat the area to be soldered prior to contacting the solder joint or pad which greatly reduces the chance of overheating and lifting the pad areas being reworked. This feature also prevents the tip from cooling during de-soldering and nearly eliminates clogging caused by cooled solder. Making them one of the most versatile desoldering tools available.

Features:

• Unique high-power heating system
• Unique dual hot air / hot tip design
• Internal pump
• N2 capable